Listing your internal user IPs allows Athos Commerce to block internal user behavior from being recorded and therefore skewing the search report data in the Searchspring management console.
Both IPv4 and IPv6 addresses are supported. You can find your IP address(es) by visiting whatismyipaddress.com.
When entering a range with a start and end address, both addresses must be from the same family (IPv4 or IPv6), and the start address must be less than or equal to the end address.
Examples:
- Single IP address
- 192.168.0.1
- 2001:db8::
- Single CIDR address
- 192.168.0.2/32
- 2001:db8::1/128
- CIDR address range
- 192.168.0.32/29
- 2001:db8::100/124
- IP address range (start - end)
- 192.168.0.10 - 192.168.0.20
- 2001:db8::10 - 2001:db8::20
Note: You can set a maximum of 100 internal user IPs.
Access your Internal User IPs by clicking the Settings menu and selecting "Internal User IPs" under the General Settings portion of the menu.
Internal User IPs
Click the "Add New Internal IP" button at the top left of the page. A new window will appear. Type in the internal IP address. You may also add the start value (mandatory IP value or start of the range) and the end value (optional, terminal IP), and (if you prefer) an optional description.
Save button
Save your changes on the bottom of the page when you're done.
Cancel button
Click the X button to discard your changes.
Editing an existing IP address
To edit an existing IP address, click the pencil icon. This will allow you to modify the values. Click the Save button to save your changes. Click the Cancel button to discard your changes.
Comments
0 comments
Article is closed for comments.